2.A separate inlet with a ceramic frit is used to aerate the perfusate.
用玻璃料制成的一个独立进暴露在灌流液中。
3.They went to a fishing village on a small inlet of the sea.
他们去了小海湾边的一个渔村。
4.The damping effect of the honeycomb can reduce the influence of the inlet preswirl on the total temperature difference.
蜂窝面的阻尼作用会削弱预旋对密封内温升特性的影响；
5.If using a split/splitless inlet, check that the purge valve is ON.
如果使用分流/不分流进样，检查分流阀是否打开。
6.In the Chang611 sandlayer, the inlet edge subface of delta deposits is complete.
长611期三角洲前缘亚相发育完整，分流相带相互叠置。
7.Besides, experiment on the pressure loss of the improved accumulator with L-Tube with the evase inlet shape was done.
对进后的L-Tube为喇叭形的储液罐也做了试验研究。
8.In terms of analysis result, an improved L-Tube with evase inlet shape is proposed.
根据分析结果，提出了相应的结构进意见——将L-Tube的为喇叭结构。
9.Inlet and outlet system,Hydraulic characteristic,Forebay,Siphon outlet piping,Efficiency of pump;
进出水系统,水力特性,前池,虹吸式出水管,水泵效率
10.It is therefore important to select the appropriate inlet liner, inlet temperature, injection technique (fast autoinjection is recommended), solvent, column installation and split ratio.
11.The structure of swirler in swirlmeter is changed.The corner dimension between inlet blades and basic shaft is changed into 45 from 60 and inlet blades into seven from six.
12.an air pump is connected with an end of the inlet duct to insufflate the sample from the sample attachment plate into the air outlet.
一空气泵，连接于进气管的一端，以将样品附着片上的样品吹出气管。
13.inlet rose box | purification apparatus | rose head | purifier | pass filter | filtrator | cold filter .
22回复：精彩的视频介绍，不看不知，你看全知，
14.The results show that the unstart boundary of supersonic inlets is mainly concerned with Mach number of freestream without considering the variation of angle of attack.
分析结果表明：在不考虑攻角变化的条件下，进气不起动边界主要与来流马赫数有关。
15.Body has handhole (or manhole) for easy wash and examination, And bottle valve set up inlet/outlet valve,safety valve, pressure gauge and pressure gauge valve, drain valve etc.
16.Two patterns of air plane engine inlet hot-air anti-icer are introduced in this paper, one is circumferential anti-icer, the other is double skin corrugated chord direction anti-icer.
17.This paper introduces the main energy saving technologies of centrifugal pump.And the author proposes a new energy saving technology which is called prerotation regulated by the inlet guide vane.
本文介绍了离心泵节能的主要技术，并提出了前置导叶预旋调节的节能技术。
18.Where rangeability is not a concern, linear trim may be used if the valve pressure drop is greater than one third of the inlet pressure (in absolute units).
在可调比无关紧要的地方，如果阀门压降大于阀前压力的1/3（绝压），可使用线性的阀内件。
19.A model was developed to predict the results of a total instantaneous blockage(TIB of a single subassembly inlet in a fast reactor at full power based on the SCARABEE-N series experiments.
20.Abstract: A model was developed to predict the results of a total instantaneous blockage （TIB） of a single subassembly inlet in a fast reactor at full power based on the SCARABEE-N series experiments.
;
;
。
；
流；输
进后的L-Tube
