slurry 专八

non-slurry pelletizing

干法造粒

the agitator in the vat keeps the slurry in suspension .

桶里的搅拌器使泥浆保持悬浮不沉底。

The BFS/HL sorbent was prepared at a weight ratio of 30/70 with a slurrying time of 16h and a slurrying temperature of 65℃.

炉/化钙吸收剂重量配为30/70，于65℃浆化16小时乾磨制备而成。

But in wet process,heat consumption is h igher for slurry vapourization.

但料浆蒸发水分需要大量热,能耗较高。

The operation of the slurry pumps for transferr in g sludge in the dilute phosphoric acid defecator in the phosphoric acid producti on is mostly not satisfactory.

磷酸生产中输送稀磷酸澄清槽淤渣的泥浆泵,各厂的运行情况都不够理想。

slurrying machinery: milling vessel, water pump, pipe and motor.

制浆机：由搅拌容器、水泵、管道和电机组成。

Make cuttlefish into mucus, use shive roll it, moisten egg slurry, bread bran and lavender on it, fry it for 6 minutes.

用面包片卷成条状，上蛋浆再沾上面包糠，熏衣草，用中火炸6分钟即成。

Objective: To compare the clinical effects of calcium hydroxide iodoform (CHI) slurry and traditional intracanal medication such as formocresol (FC), camphophenic (CP).

摘要目的：较化钙碘仿(CHI)糊剂与传统的根管消毒剂甲醛甲酚(FC)、樟脑酚(CP)的临床效果。

The expansion mechanism of hydroxide expanding phase for oil well cement slurry are discussed on the basis of principle of chemical thermodynamics and topochemical reaction model.

要基于膨胀剂原地反应模型和化学热力学原理，讨论了晶体生长压的源动力及水泥浆体体积膨胀与结晶压的关系。

The specific properties of gypsum and its slurry, the effect of different refractories on the properties of plaster molding, and how to control main process of gypseous mold are analyzed.

在大量试验究的基础上,阐述了有关膏型铸工艺的几个主要技术问题,分析了膏及其浆料的特性,各种填加物对膏型性能的影响,以及如何控制膏型铸造的主要工艺过程

The features of coal-water slurry and heat coal gas,and its process,invest and budget,profit and technology feasibility by the two kinds of fuel instead of masout were introduced.

介绍了水煤浆、热煤气2种新型燃料的特性,以及它们替代重油进行固(片)碱生产的工艺方法、投资估算、经济效益、技术可行性等,较了二者的优缺点。

Suitable for clean water, sea water, chemical liquid carrying acid and alkali, and general mushy slurry (medium viscosity ≤100 centipoise, solid content below 30%).

适用于清水、海水及带有酸、碱度的化工介质液体和带有一般糊状的浆料(介质粘度≤100厘珀、含固量可达30%以下)。

By simulated test, the co-relationship among the slip granulometric composition, slurry deflocculation curve, mid-high pressure casting forming speed and green body shaping endurance is studied.

通过模拟试验,究了泥浆的颗粒组成与泥浆的解胶曲线、高中压注浆成形速率及坯体挺形性等的关系。