She slopped around in the cooling water.

她在凉爽的水里走来走去。

Large quantities of water are needed for cooling purpose.

冷却用大量的水。

The cooling unit hasn't come on yet.

冷却装置还未工作。

The heat had to be dissipated by elaborate cooling systems.

得用复杂的冷却装置散发。

Fill the cooling system with antifreeze as a protection against frost.

在冷卻系统里加防冻剂以防止霜冻。

Cooling pumps were left off for more than an hour.

冷却泵关了一个多小时。

Put the hot broth in the refrigerator for an hour to hasten cooling.

把肉汁在冰箱中放一小时以加快冷却。

The process conditions,including presintering temperature,sintering temperature and time,cooling mode and pretreatment were studied.

对烧成程(预烧温度、烧结温度及保温时间、降温方式)及预处理工艺进行了研究。

At last, heat economy features of in-and-out dirt thermoresistance of air-cooling condenser heat sink pipe were calculated by programming.

最后,编程计算分析了空冷凝汽器散器污垢阻的经济性特性。

The subcooler is a key device of cryogenic cooling system in High Temperature Superconducting (HTS) cables.

冷器是高温超导电缆(HTS)低温冷却系统的关键设备之一。

Indirect cooling circuit via heat exchanger allowing optional heat recovery for the calorifier or cabin heating.

间接排气水冷却方式，当水流经交换器时，允许水流经任意方向通水与废气交换器或散箱。

Don't stow the hairy crab up to the deckhead. You have to keep some space for cooling.

不把河蟹堆到舱顶，你们必须留一些空间用于冷却。

The metallographic cooling rate was measured for the Deng Ujimqin mesosiderite using And profile ac concentration vs.

采用剖面中间浓度与镍纹石带宽度关系测定了东乌珠穆沁中铁陨石的金相冷却速率，其冷却速率介于0。

The RE(Y)-Mg-Si-Fe nodularizer had been used to cast heavy sectioned high ductile nodular iron cooling wall castings.

应用钇基重稀土镁复合球化剂，铸造厚大断面高韧性球铁冷却壁，成功地获得了铸件中心部位铸态高性能。

Unseam if after cooling.To serve,cut it into round slices and dip them in mashed garlic,vinegar and other sauces.

食用时切成圆形薄片，佐以蒜泥、香醋、酱料等，是一道独特的风味食品。

Due to the special properties of the thermoelectrical effect, Peltier devices can be used for both heating and cooling.

由于其特有的电效应，珀尔贴装置在加和冷却条件下都可以使用。

Slowly geostrophy, it go beyond the limit , says to the penguin: Be fond of cooling down really!

它慢慢地转头，对企鹅说：果然好冷啊！

The high wearing resistance of the samples after hydrocooling and air cooling was partially attributed to martensite transformation and work-hardening.

经水冷和空冷的试样具有高耐磨性的重原因是其在磨损程中诱发了马氏体相变,出现加工硬化现象。

Programmed cooling method: The glycerol and Dimethylsulfoxide, as cryoprotective agents, were mixed with COC1 cells suspensions at different concentration, respectively.

以甘油和二甲基亚砜为低温保护剂，分别以不同的比例添加到含有细胞悬液的冻存中。

Through utilizing controlled cooling technique on large section bearing steel bar after rolling ,an ideal initiation structure sorbide can be attained.

利用快速冷却技术，可以得到球化退火的理想预组织──索氏体。