4.Characteristics of plastic deformation of stress minerals in veins, such as subgrain tectonics, deformation, lamellae and deformation bands, can be found.
金矿的成富集与韧性剪切带多期(次)活动密切相关，尤其是韧脆性期。
5.As the material is deformed beyond the strain that elastic deformation persists, the stress is no longer proportional to strain, and permanent, nonrecoverable, or plastic deformation occurs.
当材料的超出弹性发生的范围，其应力将不再与应成正比，永久的、不可回复的发生，即为塑性。
6.The spectra show that the complexation of iodine cation doesnot lead to deformation of the macrocycle polyamine.
光谱分析表明,碘正离子的配位并未引起大环多胺构型的改。
7.What should the deformation after peritonaeum eat after tumour operation?
腹膜后畸瘤手术后应该吃什么?
8.4—韧性带及含金黄铁绢云岩带；
4—Ductile deformation zone and auriferous beresitization zone;
9.The stress distribution and amount of deformation has been counted under different pavage conditions.
计算不同情况下该种管道的应力分布及量。
10.Setout ellipse curve with the traditional method of four-center will bring up offset of point and deformation of chart .
四心圆法测设椭圆曲线会造成点位偏移,图。
11.The development of deformation theory, selection and utilization of new cultivars of Y. denudate can be based on these results.
为进一步深入开展玉兰理论、新品种选育和开发利用等研究提供了科学依据。
12.When metallic material deformation forereach its plastic limit , it will divide completely. Then the interatomic force is damaged.
断裂-金属材料在超过其塑性极限—完全分开.原子间结合力遭受破坏.
13.Pre-deformation prior to overaging remarkably refine and spheroidize the grain structure of AA2195 Al-Li alloy.
过时效前的轧制预明显细化并等轴化AA2195 铝锂合金的晶粒。
14.FFD（Free Form Deformation） is general approach for computer facial animation and express editing while troublesomely solving control point and unconspicuous deformation result.
15.Cataclastic texture which came from brittle deformation made the jadeite quality bed, but the mylonitic texture which resulted from ductile deformation made the jadeite quality good.
在强大剪切应力和钠质流体的共同作用下，铬铁矿的淡化作用是成绿色的主要原因。
16.rectangular blades with four cutting edges to prolon working life, adjustable shearing angle to reduce deformation of the sheet.
矩刀片，四个刃口均可使用，使用寿命长。剪切角可调，减少板料扭曲。
17.600℃时效后，孪晶大幅度减少，并析出M23C6碳化物而出现软化现象。
The amount of deformation twins reduced and the carbonide of Cr23C6 precipitated, which resulted in the phenomena of softening.
18.The probability of packer sticking is increased because of the casing deformation and crustation in casing failure well.
在套损井中,由于套管、结垢等因素,进一步加大了封隔器卡钻的可能性。
19.The crystallology, dislocation mechanism and geometry of twinning during plastic deformation of magnesium alloys are overviewed in this paper.
摘要介绍了镁合金过程中孪生的晶体学、位错机理以及几何位向学；
20.The deformations of dendriform-column by FEM analysis is less than the request in the code for design of steel structures.
是暂时的。
;
