isothermal 专八

The principle and equipment of sorbitizing isothermal heat treatment without lead are introduced.

指出钢丝铅浴索氏体化热处理存在问题,介绍无铅索氏体化热处理原理和设备。

The present study represents an extension of earlier work by Penner on evaporation rates for isothermal droplets.

透过光阳公司提供资料作为设定条件，估引擎操作度与分布均匀性。

Conclusions It is feasible to estimate emulsifiability to the method of isothermal curve of the surface(interfacial) tension .

结论 化剂表（界）面张力线比较法用于化剂化能力是可行。

And then, we make quantum mechanical generalization of some typical thermodynamic processes, such as isothermal process, isochoric process.

通过对一些基本热力学过程量子力学推广，我们可以直接从量子力学去理解热力学。

Isothermal precipitation behavior of the calcium cerite phase in RE-bearing blast slag was studied by quenching method.

应用“淬火法”研究了过程含稀土高炉渣中铈钙硅石相结晶行为,并讨论了该相析出和长大动力学规律。

By mathematical deduction, an inductive method for treating kinetic data of high heat intensity pyrolysis of oik under non-isothermal conditions was presented.

通过数据推导给出处理在非恒条件下油品高高热强度裂解反应动力学数据归纳方法。

To predict the slot film-cooing adiabatic effectiveness, a mathematic model was developed based on cohence non-isothermal jet theory.

摘要在伴随非射流基础上发展了一种适用于缝槽气膜冷却绝热比预估数学模型。

The dynamic rheological behavior and non-isothermal cold crystallization of poly(ethylene terephthalate)(PET)were studied to reflect the disentanglement effect of the pulsatile extrusion flow field.

通过分析 PET 熔体动态流变参数和结晶动力学过程变化,间接证实动态挤出聚合物熔体分子解缠结作用。

Meanwhile, the curing process of novalac epoxy-episulfide resin/DDS is studied according to non-isothermal DSC.

并且根据不同升速率下DSC数值推算出该反应固化工艺。

Compensation—For the rapid calibration of large numbers of thermocouples, the reference junctions can be made at an isothermal multiterminal strip.

补偿快速校准大量热电偶，路口提法，可在多端地带。

Due to the character of isothermal calorimeter,we can obtain complete thermogenic curves of cement hydration during hydration process.

通过它可以获得完整水泥水化过程产热曲线;

The equal-volume titration method was explained and was used to measure isothermal consolute points of benzene-water-ethanol ternary solutions at 25 ～45℃ in this paper.

介绍了体积法原理,通过体积法原理测定了25～45℃苯-水-乙醇三元体系会熔点,并计算了会溶点中苯质量分数与度线性规律。

Based on polytrophic process of air compression and isothermal gas combustion inside the turbine, an improved gas turbine with generality Carnot cycle is suggested.

基于气体多变压缩以及涡轮燃烧技术,提出了一种改进概括性卡诺循环燃气轮机,通过模型预测分析了其性能,并与传统燃气轮机进行了比较。

The two dimensional pseudohomogeneous model was often used for the non isothermal, non adiabatic fixed bed reactor that was widely used for the strongly exothermic reactions.

非恒非绝热固定床反应器广泛应用于强放热反应体系。

Boundary layer theorem, isothermal and isoflux vertical plates, asymmetric isoflux vertical parallel plates of free convection, optimum and maximum channel space will be discussed.

边界层理论，、热流垂直板，热流非对称之垂直两平行板自由对流以及最佳及最大气渠板距将被讨论。